STEPS
1
I-VW-CAN KIT CONTENTS REMOVE TOP AIR VENTS COVER. It is held on by clips and unsnaps when lifted with soft radio removal tool. 
2
REMOVE TWO SCREWS AS SHOWN TO ALLOW AIR VENTS TO COME OUT. 
3
PULL OFF AIR VENT UNIT. 
4
YOU CAN PLACE THIS ASIDE WITHOUT DISCONNECTING HAZARD-LIGHTS BUTTON. 
5
REMOVE ONE SCREW ON EACH SIDE OF RADIO TRIM. 
6
LIGHTLY SNAP OFF ON ALL SIDES. 
7
SCREWS HOLD THE RADIO IN PLACE (2 ON EACH SIDE). Remove these for radio to easily slide out. 
8
PULL RADIO OUT TO SEE FACTORY CONNECTIONS. Be careful not to damage dash with radio's sharp edges! 
9
UNCLIP CONNECTOR AND IT SHOULD SLIDE OFF WITH A GOOD PULL. You can also remove the two antenna connections to place radio aside. 
10
FACTORY SAT CONNECTOR (BLUE) SHOULD BE REMOVED FROM FACTORY PLUG. 
11
HOLD ONTO DICE I-VW-CAN RADIO HARNESS. 
12
MATE FACTORY FEMALE PLUG WITH DICE MALE PLUG. 
13
LOCK IN PLACE. 
14
PUSH BACK WIRING CAREFULLY INSIDE DASH. 
15
FROM THE DICE HARNESS, FIND THE 12-PIN MOLEX CONNECTOR. 
16
SNAKE THE CABLE THROUGH THE GAPS BEHIND DASH TO HAVE IT COME INSIDE THE GLOVE BOX. 
17
DICE FEMALE PLUG CAN BE CONNECTED TO THE BACK OF THE RADIO AND LOCKED IN PLACE. 
18
SLIDE RADIO BACK IN PLACE, MAKING SURE THE WIRES ARE NOT BEING PINCHED. Again be careful not to damage dash with radio's sharp edges! 
19
CONNECT 12-PIN MOLEX AND IPOD CONNECTOR TO DICE MODULE. 
20
DICE MODULE CAN BE STORED IN GLOVE BOX. This gives easy access to auxiliary input on DICE module. 
21
AFTER TESTING UNIT FOR PROPER OPERATION, FOLLOW STEPS 1-8 IN REVERSE TO REPLACE ALL SCREWS AND COMPONENTS FOR FINALIZED INSTALLATION. Text on radio display and cluster in between gauges.
Up close radio screen shot.
SOURCES AND CITATIONS
http://www.carintegrationkit.com/
ARTICLE INFO
Categories: IPods | IPhone
Recent edits by: Fighting Irish Fan, LinkAcar
Discuss
No comments:
Post a Comment